China manufacturer of magnetic ballasts for metal halide flood lights & hps flood lights

Though most aquarium tank lids usually are not overly pricey, it really is nonetheless a great thought to replace the light ballast when it stops doing work. When the light flickers excessively whenever you flip the light on or the light does not electrical power on whatsoever, it is time for you to change the ballast. Simple family equipment are necessary to alter the ballast and a extremely fundamental understanding of electricity is required. However, transforming the ballast is just not an overly complicated course of action.
Instructions:
A).Take out the florescent light bulb through the aquarium bonnet by rotating it counterclockwise. You will find two pins on every end with the light. People pins line up using the grooves around the ballast brackets. Using the pins lined up, pull the light out of the ballast brackets.

B).Clear away the JAMES screws that secure the reflector plate towards the within of the aquarium bonnet and then lift the reflector plate from the bonnet.
C).Take out the ballast brackets from your reflector place by pulling outward on them. They aren't bolted into place; they snap on. These brackets aren't reused given that they are hard-wired to the ballast. The brand new ballast is equipped with new ballast brackets.
D)Remove the wire nuts that cover the wire connections among the ballast and the electrical switch. Create down which colour wire connects to each and every side in the switch. A single wire is black and one wire is white. The brand new wires connect during the similar manner.

E)Clear away the bolts that secure the ballast on the bonnet. Spot the brand new ballast in to the bonnet and secure it into place applying the old bolts.

F)Connect the white wire plus the black wire to your electrical switch and safe the wire nuts into place.

G)Location the ballast brackets onto the ends from the reflector shield. Carry on to push inward on them until they snap into location.

H)Location the reflector to the bonnet and safe it using the outdated bolts.

I)Location the pins found on every finish with the florescent light in to the grooves within the ballast brackets and turn the light clockwise to safe it into area.