China manufacturer of magnetic ballasts for metal halide flood lights & hps flood lights

How to install the T8 LED tube?
Due to the current LED lights gradually in the market spread, and T8 LED tube and traditional fluorescent lamp tube is not the same power supply, to care for the majority of the products consumers. Clear the lamp installation. Today, specifically the personal experience of sorting out, hope all of you help now led lamp basically are built in power supply, so basically is to replace the existing fluorescent lamp mainly, and with traditional fluorescent lamps and two kinds: magnetic fluorescent lamp, electronic fluorescent lamp.

Below are 2 different lamps of the replacement method

1,Magnetic fluorescent lamp: there are basically electrician basic knowledge are clear, traditional fluorescent lamp: bracket, ballast, Kai Hui, fluorescent tube, the four part and replaced LED lamp need only need to open the starter is pulled out, can let replaced with LED lamp normal use. However, to allow maximum power, there is also a need to support ballast circuit and removed. The reason for doing so is because ballast does not remove the will has been at work will cause unnecessary waste of electric energy.

2, electronic fluorescent lamp: and the lamps and lanterns of electronic transformation relatively trouble some, because working mode and town of electronic stream of completely different, so when used in this type of lamps must support electronic ballast which short circuits completely, in order to make LED tube normal use.